Description
Dental Wet Model Shaping Trimmer Abrasive Diamond Disc Wheel Lab Equipment New Supply by Super Dental
View AllClose
- 1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
- 2. Connect the waste-disposal tube to the unit
- 3. Connect the power cord, and switch on the power switch (O=off, l=on)
- 4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
- 5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
