Description
2in1 AHD 1080P License Plate Backup Camera for Car, Truck, SUV, Minivan, Camper, RV, Pickup, GreenYi Video Format Switch Button Rear Front View License Plate Frame Camera
View AllClose
- AHD 1080P High Definition Backup Camera---2083 sensor chip, video switch button,1920*1080 Pixels, 0.01 flux to support high quality night vision image, 170 degrees viewing angle, no worry about blind spot area, IP68 waterproof, works properly under car washing or bad weather, fantastic night vision effect, can be used on Truck, SUV, Minivan, Camper, RV, Pickup and so on.
- SUPPORT BOTH AHD AND CVBS VIDEO SIGNAL---With the video switch button, this vehicle license plate rear view camera can work with both ALL AHD monitors and CVBS monitors. Its output video signal is CVBS by default, if you need it to connect with a AHD monitor, please press the button for 5 seconds to switch to the video format needed. AHD video signal image is much clearer than CVBS.
- CAN BE USED AS BOTH REAR AND FRONT VIEW CAMERA---This license plate camera is with guideline and shows mirror image used as reverse camera by default. If you want to use it as a front camera, please cut the green, then the guideline will turn off. NOTE: Please unplug and reconnect the 4-pin power cable after cutting the green wire.
- DIFFERENT INSTALLATION METHODS FOR YOUR CHOICE---For our license plate camera, you can install it behind or in front of the license plate, or you may apply the mini bracket and install it above the license plate.
- IP68 Rated Waterproof Reverse Camera---When manufacturing the reversing camera, we have tried our best to upgrade the waterproof grade. We have fulfilled the whole camera body with waterproof silicon rubber, we tested every single camera under water for 24 hours, it will work properly under extreme conditions.
- Backing Camera Work With Monitors Supports RCA Connection---This backing up camera only works with monitors which supports RCA connection. For normal mirror monitors or TFT monitors, no need to use the trigger detection cable. When it works with a radio head unit, please remember to connect the trigger wire.
